The Clip Whacker is a set tool used to hammer on flange clips for running conduit, MC, Reloc, data cable, and other means of piping. Clip Whacker uses a rare earth magnet to hold clips in place and make loading the next clips faster. 

Hammer on your beam clamps with one swing on the first try every time. No more banging them on with your linesman’s, injuries from hitting your hands, or clips flying at your face. 

Clip Whacker gives you a wide surface area to aim at, keeping your fingers safe and helping you install clips more efficiently. Work faster while also reducing the chance of injury, Clip Whacker is a win-win for both electricians and contractors. 

• Fits all sizes of flange: 1/8”- 1/4”, 5/16”- 1/2” and 9/16”- 3/4”. 
• Made in the USA. 
• FAST – Hammer on beam clamps the first time – every time. Install bang-on minnies in seconds to finish jobs in half the time. Just load a clip, line it up, and hammer away. 
• MAGNETIC – Clip Whacker holds your hammer-on beam clamps in place using a rare earth magnet. This strong magnet keeps a tight hold on your clips so you can work faster. 
• SAFE – You don’t have to worry about hitting your thumb anymore. Enjoy a bigger target for your hammer and reduce the risk of injured hands. The hammering surface is rounded and wider than the tool to protect your hands. 
• PORTABLE – The Clip Whacker is small enough to fit in any tool pouch or bag and the aircraft-grade aluminum makes it lightweight and easy to maneuver. 

More Information:

Here’s How the Clip Whacker Simplifies Beam Clamp Installation: 

1. Place the beam clamp onto the Clip Whacker.  
2. Hold onto the Clip Whacker with your hands. To help, hold the minnie with two fingers and press the clamp against the beam.  
3. Hammer the end of the Clip Whacker and within 1 or 2 hits the clip will be installed.   

We ran a test to see how much time you can save with Clip Whacker. Two electricians in scissor lifts raced to see who could hammer on 100 minnies quickest. One of them used the Clip Whacker. The electrician with the Clip Whacker installed all 100 beam clamps before the other was half done. Double your productivity with Clip Whacker.